Flat-Trac ® III CT Tyre Test Bench
The test bench permits high-level precision tyre measurements under stationary and dynamic operating conditions and thus optimises the model quality of tyre and vehicle simulation models. The test bench is located in a separate, enclosed test hall including office, assembly zone and storage rooms to ensure absolute confidentiality for all customers. IABG handles test operations, quality management, service and maintenance andprovides a wide range of further services.
Task • Service
- Determination of characteristics, stationary and dynamic measurements
- Standardised test procedures (e.g. TIME)
- Definition of tyre parameters
- Special tyre measurements
- Customer-specific assignments
| Technical Data | |
|---|---|
| Max. setting values | |
| Tyre diameter | 910 ± 0,25 mm |
| Tyre width | 450 ± 0,25 mm |
| Speed | 250 ± 1 km / h |
| Spindle drive | 2.800 ± 20 Nm 1.100 ± 13 rpm |
| Slip Angle | ± 30 ± 0,01 ° |
| Adjustment speed | 50 ± 1 °/s |
| Inclination Angle | -12 … 45 ± 0,01 ° |
| Adjustment speed | 5 ± 0,1 ° / s |
| Wheel load Fz | 25.000 ± 1 % N |
| Movement speed vz | 300 ± 3 mm / s |
| Tyre pressure | 700 ± 5 kPa |
| Max. measured values | |
| Longitudinal force Fx | 10.000 ± 1 % N |
| Lateral force Fy | 15.000 ± 1% N |
| Camber torque Mx | 10.000 ± 1% Nm |
| Driving and braking torque | 3.000 ± 1% Nm |
| Rolling resistance torque My | |
| Bore or self-aligning torque Mz | 3.000 ± 5 Nm |
